Unit Usp 1020d Instruktsiia -

Open the battery compartment on the bottom. Insert 4 AA batteries, ensuring correct polarity (+/-).

The will flash. Use the MEM button to change the value, then press SET to confirm. Repeat this process for Month , Day , Hour , and Minute . Preparing for Measurement

Press the MEM button. It will first show the average of the last 3 readings. Press it again to scroll through previous entries. unit usp 1020d instruktsiia

Before taking your first measurement, ensure the device is configured correctly. 1. Power Supply

Do not smoke, drink caffeine, or exercise for 30 minutes prior. Open the battery compartment on the bottom

To get the most accurate results, follow these preparation steps: Sit quietly for 5 minutes before starting.

With the device OFF, press and hold the button for 3 seconds. Use the MEM button to change the value,

Sit upright in a chair with your back supported and feet flat on the floor. Cuff Placement: Place the cuff on your bare left arm. Position it about 1–2 cm (0.5 inches) above the elbow. The air tube should run down the center of your inner arm. 🩺 Taking a Measurement Press the START/STOP button.